Configuration: Network > Routing - VBrick 6000 series Admin Manual

Network Time Synchronization
These fields are used to synchronize network time using the host name or IP address of a
known server to provide a synchronized time for all appliances in the network. To enable
Network Time Synchronization
General on page 47 and check the box.
Note To Network Administrators. DHCP Option 4 is used by the DHCP server to return
SNTP server addresses. This option must be enabled in the DHCP server for these
addresses to be returned to the VBrick. If the DHCP server configuration is unknown,
it is recommended that the address(es) be manually entered since the DHCP server-
supplied address will always override a manually-entered address.
Primary Server IP Address
or Host Name
Secondary Server IP
Address or Host Name
Configuration: Network > Routing
The MPEG-4 Appliance requires no routing configuration for the vast majority of network
uses. Use these settings only in those rare cases when your network requires advanced routing
features in the appliance.
VBrick MPEG-4 Appliance Admin Guide
after these parameters are set, go to Configuration: System >
Primary host name (VBrick Host Name or DNS Host Name)
or IP address of valid SNTP server providing time
synchronization. A blank field indicates the server address
will be acquired via the DHCP server only if the
field above is checked.
DHCP
Secondary host name (VBrick Host Name or DNS Host
Name) or IP address of valid SNTP server providing time
synchronization. A blank field indicates the server address
will be acquired via the DHCP server only if the
field above is checked.
DHCP
MPEG-4 Configuration
Network
Network
7