VBrick 6000 series Admin Manual page 28

Connection
Protocols
Encoder IWS Port The decoder will try to extract the SDP information from the host
Connection Mode: Program Name
Connection Mode
Available Programs A drop-down list for available programs is automatically created from
SAP IR Program
Guide
18
The VBrick can connect to the encode source in three ways: Unicast,
Multicast, RTSP. The VBrick decoder will attempt to connect in this
order. Once the connection is established, if for some reason the
connection is lost, the decoder will attempt to reconnect automatically.
Note: When tuning to an encoder that is unicasting to this decoder via
a Firewall/ NAT, only the unicast option should be enabled. Address
resolution behind a NAT/Firewall may make it difficult for the
decoder to match the sender's IP address. Selecting only Unicast will
help alleviate the issue.
using an HTTP get. The host may not be running on port 80 to supply
the HTTP based SDP and may be running on a different port.
Management SAP information may contain the host's HTTP port.
The port value in the SAP overrides the configured HTTP port
through this parameter when requesting HTTP data from the device.
Program Name. In this example the decoder will try to connect to the
encoder with the program name "BillsMP4 Program 1."
other active devices on the network.
A program guide of available streams can be displayed on the TV or
monitor using the IR remote.
© 2009 VBrick Systems, Inc.