Configuration: Passthrough - VBrick 6000 series Admin Manual

Conferencing
Setup
Conferencing
Accept
Local Ringer
Conference End
Display Mode
Local Ringer IR
Conferencing
Name
SAP IP Address
SAP Port
SAP Retransmit
Time

Configuration: Passthrough

The TCP/IP network can serve as an intermediary between two VBricks and their serial
ports or between a PC application sending IP packets and a VBrick's serial port. Passthrough
42
This option enables/disables the ability of a user to initiate a
conference using an IR remote control unit. Disabled prevents this
VBrick from appearing on the Conference Guide of other VBricks.
If , the called party on this VBrick must explicitly accept the
Manual
call with the IR remote control. If automatic, the call will be accepted
without any action on the part of the called party.
Used to enable/disable the ringer.
Allows the choice of what is displayed when the conference ends.
Display either Picture-in-Picture (with the local encoder view) or a
Blank Screen.
If Enabled, the ringer may be enabled or disabled via the IR remote by
the user (operator) of this VBrick. If disabled, the local operator
cannot change the state of the ringer. It will remain as set above in
"local ringer".
Used to configure the name of the user (operator) of this VBrick. This
is the name, which will appear on the conference guide screen used to
set up the conference. The default entry is \h or \H, which identifies
the unit by the Host Name of VBrick appliance.
The SAPs for Conference Call setup are sent to this destination IP
Address.
The SAPs for Conference Call setup are sent to this destination IP/
UDP port.
Allows setting the SAP retransmit time.
© 2009 VBrick Systems, Inc.