Table of Contents
Advertisement
COM Interface
Type
Passthrough State: Responder
Baud Rate
Stop Bits
Parity
RTS Control
DTR Control
Operational State
44
Describes the COM interface connector. (RS422/485 options are
displayed only if main board has a Part Number ending in xxx3. See
Status: User Information > Main Board.)
• RS232 – standard RS-232 serial port connector.
• RS422/485 – RS-422/485 4-wire serial port connector.
• RS422/485 (Terminated) – RS-422/485 terminated.
Rate can be set to the following (Default = 9600):
110, 300, 600, 1200, 2400, 3600, 4800, 7200, 9600, 14400, 19200,
28800, 38400, 57600, 115200.
Number of stop bits for Passthrough port (1 or 2).
None, Even, Odd.
Force Off, Force On or Automatic. If automatic, the control will be
on when Passthrough is active. DTR and RTS are available for COM2
only for those VBrick models whose last digit is 3 or higher. Under no
conditions are RTS or DTR controls passed through end-to-end. All
control handling is local.
Force Off, Force On or Automatic. If automatic, the control will be
On when Passthrough is active. See note above.
Describes the current status of a Passthrough connection, including
error conditions, if any. Refer to the Network Status Section. This will
display "Active" if in Passthrough mode.
© 2009 VBrick Systems, Inc.
Hide quick links:
Advertisement
Table of Contents
