VBrick 6000 series Admin Manual page 27

Note Source-specific multicast is enabled by IGMPv3 and provides a way to share a limited
number of multicast addresses on IGMPv3 networks. It lets your decoder associate a
multicast address with a specific source encoder IP address. Source-specific multicast
is designed for multicasting across networks and has no benefit when sharing multicast
addresses on the same subnet (unless your router supports IGMPv3 snooping).
Multicast addresses in the 232/8 (232.0.0.0 to 232.255.255.255) range are reserved for
source-specific multicast. Enter the multicast address as the "Destination IP Address
or Host Name" parameter on the Configuration: Encoder > Destination IWS page.
There is no other configuration for source-specific multicast on MPEG-4 encoders or
decoders.
Receive
Connection Mode
Remote Slot
VBrick MPEG-4 Appliance Admin Guide
This option enables or disables the decoder.
There are several choices for telling the decoder how to connect to a
stream. In order to make other options visible you will need to select
the Connection Mode you want to use and click
mode when applied gives you a drop-down list
Address or Hostname
called Available VBricks that will list all available encode sources. See
examples that follow for other Connection Modes.
The unit may contain dual decoders so you must select the appropriate
slot which represents decoder #1 or decoder #2.
MPEG-4 Configuration
. The
Apply VBrick IP
17