Winterizing The Fastlane Pool; Disassembling The Fastlane Pool - Endless Pools FASTLANE Owner's Manual

Page 29 of 32
Weekly
Check and adjust the water level. The water should completely cover the
honeycomb grill where the current is produced. Water levels greater than
1/2" lower than this can create a choppy current and may cause the skimmer
to draw air into the plumbing lines. Having the water level 1" or more higher
than that honeycomb grill can cause more water to splash out of the pool.
Test the pH level at least twice a week. Broadcast (i.e. pour chemical into the
current) pH increaser or pH decreaser to maintain levels between 7.4 and 7.8.

Winterizing the Fastlane Pool

Take the Fastlane Pool down and/or re-install it indoors if desired when living in an
area where harsh winter weather occurs.
"Winterizing" is specific to the climate in which the pool is located. "Winterizing"
generally refers to the treatment of the water in the pool, draining the pool water
below the Fastlane Swim Unit and draining the equipment, but the pool structure
alone requires no special attention.
If it is desired to winterize the Fastlane Pool, the water level must be drained below
all wall fittings and below the Fastlane Swim Unit. Additionally, the plumbing fittings
need to be disconnected from the pool wall at the respective unions and stored in a
dry and safe place. Be careful not to lose the o-rings of the unions if doing this.
If storing the pool, thoroughly clean and dry the liner before carefully rolling it up.
Store the pool and Fastlane Swim Unit in a dry safe place. Store the structural parts
separate from the liner (preferably in boxes) to protect the liner from damage.
It is okay for the Hydraulic Power Unit to remain outside with the hydraulic run hoses
in the wintertime, as the fluid inside will not freeze. The hydraulic run hoses will
need to be capped, however, to prevent any fluid from draining out.
Please contact Endless Pools Customer Service Department at 1-800-910-2714 with
any questions or concerns.

Disassembling the Fastlane Pool

Unhook the hydraulic hose connections at the Hydraulic Power Unit and cap all ends
to prevent hydraulic fluid from draining.
Pull the hydraulic hoses through the grommet holes (if applicable) and lift the
Fastlane Swim Unit with hanger from the pool wall. Pull the Fastlane Swim Unit out
of the pool carefully so as not to damage the pool liner fabric.
Once the pool is drained, reach in each corner pocket and pull the liner away from
the top rail tubes.
Once the liner is loose from the top rail, walk around the outside perimeter of the
pool moving the wall back and forth to loosen the top rail and corner pieces.
Begin disassembling Fastlane Pool by removing the corners from the structure. Be
very careful to slowly pull the corners from the top rails. Jolting or forcing
the corner out of the top rail can create a tear in the corner of the liner.
Once the corners are off, lift the top rails off of the struts and disassemble the
remainder of the pool. Be sure the liner is clean and fully dry before storing.
FLPoolOMWMWQSver1.4.a 2/3/09