Iologik E1214 - Moxa Technologies ioLogik E1210 User Manual

ioLogik E1200 Series

ioLogik E1214

Inputs and Outputs
Digital Inputs: 6 channels
Relays: 6 channels
Isolation: 3k VDC or 2k Vrms
Digital Input
Sensor Type: Wet Contact (NPN or PNP), Dry Contact
I/O Mode: DI or Event Counter
Dry Contact:
• On: short to GND
• Off: open
Wet Contact (DI to COM):
• On: 10 to 30 VDC
• Off: 0 to 3 VDC
Common Type: 6 points per COM
Counter Frequency: 250 Hz
Digital Filtering Time Interval: Software configurable
Relay
Note: Ambient humidity must be non-condensing and remain between 5 and 95%. The relays of the ioLogik
E1214 may malfunction when operating in high condensation environments below 0°C.
Type: Form A (N.O.) power relay
Contact Current Rating:
Resistive Load: 5 A @ 30 VDC, 250 VAC, 110 VAC
Breakdown Voltage: 500 VAC
Relay On/Off Time: 1500 ms (max.)
Initial Insulation Resistance: 1000 mega-ohms (min.) @ 500 VDC
Mechanical Endurance: 5,000,000 operations
Electrical Endurance: 100,000 operations @ 5 A resistive load
Contact Resistance: 100 milli-ohms (max.)
Pulse Output: 0.3 Hz at rated load
Power Requirements
Input Voltage: 12 to 36 VDC
Input Current: 188 mA @ 24 VDC
MTBF (mean time between failures)
Time: 808,744 hrs
Standard: Telcordia SR332
1-8
Introduction