Sub-Menu Operat.time; Sub-Menu Defrost; Sub-Menu Language - Danfoss DHP-A Installation Manual

Installation Guide
Menu selection Meaning
Shows the actual temperature for brine out.
BRINE OUT
Only appears if POOL is selected. Shows the actual pool temperature. The set pool temperature is
POOL
shown in brackets.
Indicates temperature.
COOLING
Only appears if SHUNT GROUP is selected. Shows the actual supply temperature. The calculated supply
SHUNT GROUP
temperature to the shunt group is within brackets.
Shows the temperature of the second heating circuit if installed by the buffer tank system.
2ND HEAT CIR.
Only appears if CURRENT LIMITER is selected. Shows the actual current consumption. The set value for
CURRENT
MAX CURRENT is shown in brackets.
8.5

Sub-menu OPERAT.TIME

Menu selection Meaning
Compressor operating time for both heating and hot water production.
HEAT PUMP
OPERAT. TIME AUX. HEATER 1.
AUX. HEAT 1
OPERAT. TIME AUX. HEATER 2.
AUX. HEAT 2
OPERAT. TIME AUX. HEATER 3.
AUX. HEAT 3
HOT WATER Operating time for hot water with compressor.
Operating time cooling.
COOLING
Operating time active cooling.
ACT COOLING
8.6

Sub-menu DEFROST

Menu selection Meaning
Total number of defrosts carried out.
DEFROSTS
The operating time of the compressor in minutes between the two last defrosts.
BETW. 2 DEFR
TIME LAST DEFR The operating time of the compressor in minutes since last defrost.
High speed is deactivated at this temperature and low speed is activated.
FAN H OFF AT
DEFROST CURVE Used to change the angle of the defrost curve using + or– (Change the start temperature
for defrost).
Used to perform a manual defrost. Started using + or -.
MANUAL DEFR
8.7

Sub-menu LANGUAGE

Menu selection
SVENSKA
ENGLISH
DEUTSCH
NEDERLANDS
FRANÇAIS
ESPAÑOL
ITALIANO
NORSK
DANSK
SUOMI
EESTI
Danfoss Heating Solutions
Domestic heat pumps
VMGFQ102
Factory
setting
-
-
-
-
Factory setting
-
-
-
Factory setting
-
-
-
12°C(range: 10°C / 20°C)
-10°C(range: -13°C / -7°C)
0(range: 0 / 1)
41