Changing Heat Curve And Desired Room Temperature; Setting Current Time - Danfoss DHP-AT User Manual

User Guide
7.4

Changing heat curve and desired room temperature

Changing heat curve and desired room temperature is only available in AUTO mode.
Heat curve
1. To select another heating curve, press
2. Use
or
3. Press
again.
4. Use
or
5. Press
again and wait 5 seconds.
Desired room temperature
1. To select the initial desired room temperature, press
2. Use
or
3. Press
again.
4. Use
or
5. Wait 5 seconds for the change to be saved.
7.5

Setting current time

1. To change the default time setting, press
2. While the symbols are flashing adjust the default hour setting by using the
3. Press
again.
4. Use
or
5. Before the flashing stops, press
16
DHP-AT
buttons to navigate to Menu 00.
buttons to select a new heating curve (range is 24-50).
buttons to navigate to Menu 01.
buttons to select the initial desired room temperature.
buttons to change the default minute setting.
again or wait 5 seconds to save the settings.
VUGFC302
for 5 seconds.
for 5 seconds.
.
or buttons.
Danfoss Heating Solutions