Danfoss DHP-A Installation Manual page 15

Installation Guide
Install the top cover
Install stand cover
Danfoss Heating Solutions
Domestic heat pumps
1. Hook the top cover at the front edge on the front cover.
2. Secure the top cover using a screw on each side. Use 2 x cross
head screws.
3. Install and screw the top cover into place
If the top cover does not align
N
with the side cover plates it may
be necessary to drill new 3 mm
holes:
1. Hook the cover onto the stand.
VMGFQ102
1. Mark for the new holes
2. Lift off the top cover
3. Drill the holes
15