Specifying UDP Event logging
Follow this procedure to enable logging to a UDP Syslog program.
Step
Procedure
1
Select the System Log link.
•
The messages will be sent via UPD packets to the Syslog port (514) of
the specified host.
•
It is up to the host program to listen to these messages for processing.
•
A syslog host program is necessary to use this method, such as, Kiwi
Syslog Daemon or WinSysLog.
2
Select the link for the log name you want to view or configure (the default
choices are log1 or log2).
3
Select the UDP Syslog radio button.
4
Enter a valid IP address or domain name.
5
Select Submit.
6
Log in as a root User if you are so prompted. (Note: Any change of a
setting will only be accepted after you have successfully logged in.)
DTC1000/4000/4500 Ethernet User Guide – Installation Guide
L001411 (Rev.1.0)
35