Panasonic KX-TDA100 Features Manual page 232

1.25 Administrative Information Output Features
[Explanation]
The following table explains the SMDR contents which are based on the numbers in the
previous pattern examples. For the programmable items, refer to the following
[Programmable Items].
Number in
Pattern
232 Feature Guide
the Item
(1) Date
(2) Time
(3) Ext
(Extension)
(4) CO (Trunk)
(5) Dial Number
(6) Ring
Shows the date of the call.
Shows the end time of a call as Hour/Minute/AM or PM.
Shows the extension number, floating extension number,
etc., which was engaged in the call.
Also shows the following codes:
Dxxx: Outgoing trunk call from a doorphone
(xxx=doorphone number) (
Txxx: Outgoing trunk call by TIE line service (xxx=trunk
group number)
*xxx: Verified call (xxx=verified code) (
Code Entry)
Shows the trunk number used for the call.
For patterns A and B, "00" will be shown for trunk
numbers over hundred.
[Trunk Call]
Outgoing Trunk Call
Shows the dialled telephone number.
Valid digits are as follows:
0 through 9, , #
P: Pause
F: EFA signal
=: A Host PBX Access code (
Code (Access Code to the Telephone Company from a
Host PBX))
. (dot): Secret dialling
X: Privacy dial
–: Transferred call
If the transfer destination extension enters some digits,
the entered digits will be added after "–".
Incoming Trunk Call
Shows <I> + the caller's identification name/number.
It is also possible to show the DDI/DID/MSN call
information. In this case, <D> + DDI/DID/MSN
name/number is added before <I> .
[Outgoing Intercom Call]
Shows the dialled extension number followed by "EXT".
[Log-in/Log-out]
Shows the log-in or log-out status.
Shows the ring duration before answering a call in
Minutes/Seconds.
Description
1.16.1 Doorphone Call)
1.8.6 Verified
1.5.4.7 Host PBX Access