System Data Control; Pc Programming - Panasonic KX-TDA100 Features Manual

2.3

System Data Control

2.3.1

PC Programming

Description
This PBX can be programmed and administered using a personal computer (PC). There are
two programming methods:
1)
On-site Programming: System programming/diagnosis can be performed locally by
connecting a PC to the PBX directly.
2)
Remote Programming: System programming/diagnosis and data upload can be
performed from a remote location.
1.
On-site Programming:
Using the Serial
Interface (RS-232C)
port
Using the USB port
Using the LAN
interface (KX-
TDA100/KX-TDA200
only)
Using a modem
through an SLT port*
(KX-TDA30/KX-
TDA100/KX-TDA200
only)
Using an ISDN TA
interface (64 kbps)
through an ISDN
Extension Line*
*: If remote access is disabled through system programming (
Method
The PBX has a Serial Interface (RS-232C) port which can be
used for either system administration or SMDR (
Station Message Detail Recording (SMDR)).
The PC is connected to the USB port on the PBX, or a USB
port (USB Module) attached to a DPT.
A CTI-LINK card must be installed.
An RMT card must be installed. Assign the floating extension
number of the analogue remote maintenance (
Floating Extension Number [811]), and dial this number from
the PC to connect to the PBX.
Assign the floating extension number of the ISDN remote
maintenance (
[812]), and dial this number from the PC to connect to the
PBX. The RMT card is not required for this method.
This method is available only when a user-supplied ISDN TA
that supports CAPI is used.
Programming [810]), then this on site programming cannot be done.
2.3 System Data Control
Description
ISDN Remote Floating Extension Number
1.25.1
Modem
Remote
Feature Guide 297