Flash/Recall/Terminate - Panasonic KX-TDA100 Features Manual

1.10.6 Flash/Recall/Terminate

Description
The FLASH/RECALL button (Flash/Recall mode or Terminate mode) or Terminate button
(Terminate mode) is used when a PT user disconnects the current call and originates another
call without hanging up first. It performs as going on-hook and then going off-hook.
[Explanation of Each Mode]
Flash/Recall Mode: Disconnects the line and the extension user hears the dial tone from the
line used last. For example, if a trunk call is disconnected, the extension user will hear a new
dial tone from the telephone company.
Terminate Mode: Disconnects the line and the extension user hears the dial tone determined
by the Line Preference—Outgoing setting. (
Conditions
• FLASH/RECALL Button Mode
One of the following modes can be selected for each extension through system
programming:
– Flash/Recall mode
– Terminate mode
– External Feature Access (EFA) mode. (
• Terminate Button
A flexible button can be customised as the Terminate button.
• Disconnect Time (Only for Flash/Recall Mode)
The amount of time between successive accesses to the same trunk is programmable for
each trunk port (
• This feature outputs an SMDR call record (
(SMDR)), restarts the call timer, inserts the automatic pause, and checks the TRS/Barring
level (
• If the ARS mode is on (
established through the INTERCOM button or ICD Group button, the Terminate mode will
be always effective even though the Flash/Recall mode has been set.
Feature Guide References
1.19.2 Flexible Buttons
LCOT Disconnect Time [418]).
1.8.1 Toll Restriction (TRS)/Call Barring (Barring)) again.
1.9.1 Automatic Route Selection (ARS)) or if a trunk call is
1.10 Conversation Features
1.5.5.2 Line Preference—Outgoing)
1.10.7 External Feature Access (EFA))
1.25.1 Station Message Detail Recording
Feature Guide 123