Danfoss VLT AutomationDrive FC 300 Instruction Manual page 12

2. Safety Instructions and General Warning
FC 301 A1 enclosure: When safe stop is included in the drive, position 18 of Type Code must be
either T or U. If position 18 is B or X, Safe Stop Terminal 37 is not included!
Example:
Type Code for FC 301 A1 with Safe Stop: FC-301PK75T4Z20H4TGCXXXSXXXXA0BXCXXXXD0
2
It is designed and deemed suitable for the requirements of Safety Category 3 in EN 954-1. This
function is called safe stop. Prior to integrating and using safe stop in an installation, a thorough
risk analysis must be carried out on the installation in order to determine whether the safe stop
functionality and safety category are appropriate and sufficient. In order to install and use the
Safe Stop function in accordance with the requirements of Safety Category 3 in EN 954-1, the
related information and instructions of the FC 300 Design Guide MG.33.BX.YY must be followed!
The information and instructions contained in the Instruction Manual are not sufficient for a correct
and safe use of the safe stop functionality!
10
MG.33.A9.22 - VLT is a registered Danfoss trademark
®
VLT AutomationDrive FC 300 Instruction
Manual