Configuring Management Service Interfaces - HP WL520 User Manual

configuring management service interfaces

configuring management service interfaces
configuring management service interfaces configuring management service interfaces
Figure 4-9 Figure 4-9 Management Services Configuration Screen Management Services Configuration Screen
Figure 4-9 Figure 4-9 Management Services Configuration Screen Management Services Configuration Screen
snmp-based management interface bitmask snmp-based management interface bitmask snmp-based management interface bitmask snmp-based management interface bitmask
Configure the interface or interfaces (Ethernet, Wireless-A, Wireless-B, All Interfaces) from which you will manage the WL520
device via SNMP. You can also select Disabled to prevent a user from accessing the WL520 device via SNMP. Reboot the
WL520 for this setting to take effect.
http access http access http access http access
Several configuration options are available that restrict access to the Web interface. Reboot the WL520 for any changes to
take effect.
– HTTP Interface Bitmap. Configure the interface or interfaces (Ethernet, Wireless-A, Wireless-B, All Interfaces) from which HTTP Interface Bitmap.
HTTP Interface Bitmap. HTTP Interface Bitmap.
you will manage the WL520 device via the Web interface. You can also select Disabled to prevent a user from accessing
the WL520 device from the Web interface.
– HTTP Port. HTTP Port. Configure the HTTP port from which you will manage the WL520 device via the Web interface. By default, the HTTP Port. HTTP Port.
HTTP port is 80.
telnet configuration settings telnet configuration settings telnet configuration settings telnet configuration settings
Use the Services tab to set the Telnet port, timeout, and session parameters.
– . Select the interface(s) (Disabled, Ethernet, Wireless A, Wireless B, All Interfaces) from which you
Telnet Interface Bitmask Telnet Interface Bitmask
Telnet Interface Bitmask Telnet Interface Bitmask
can manage the WL520 device via telnet. This parameter can also be used to Disable telnet management. Reboot the
WL520 for this setting to take effect.
– . Enter the Telnet Port. The default port number is 23.
Telnet Port Telnet Port Telnet Port Telnet Port
–
Login Idle Timeout (seconds) Login Idle Timeout (seconds)
Login Idle Timeout (seconds) Login Idle Timeout (seconds)
the session when it times out.
–
Session Idle Timeout (seconds) Session Idle Timeout (seconds) Session Idle Timeout (seconds) Session Idle Timeout (seconds)
The WL520 will terminate the session on timeout.
NOTE:
See Configure Serial Port Interface Settings
. Enter the number of seconds the system will wait for a login attempt. The WL520 terminates
. Enter the number of seconds the system will wait during a session while there is no activity.
for information on the serial port parameters.
Management Settings
4-10