Configure Mac Access Control - HP WL520 User Manual

configure management ports configure management ports
configure management ports configure management ports
[Device Name]>set snmpifbitmask <0, 1, 4, 8, 15 (default is 15 see below)>
[Device Name]>set httpifbitmask <0, 1, 4, 8, 15 (default is 15 see below)>
[Device Name]>set telifbitmask <0, 1, 4, 8, 15 (default is 15 see below)>
Choose from the following values:
interface bitmask interface bitmask interface bitmask interface bitmask
0 = disable (all interfaces)
1 = ethernet if
4 = pcCardA if
8 = pcCardB if
15 = allInterfaces
edit management ip access table edit management ip access table edit management ip access table edit management ip access table
[Device Name]>set mgmtipaccesstbl <index> ipaddr <IP address> ipmask <subnet mask>
configure serial port interface configure serial port interface configure serial port interface configure serial port interface
NOTE:
To avoid unexpected WL520 performance, leave Flow Control value at default (none) unless you are sure what this
setting should be.
[Device Name]>set serbaudrate <2400, 4800, 9600, 19200, 38400, 57600>
[Device Name]>set serflowctrl <none, xon/xoff>
[Device Name]>show serial
Figure 6-14 Figure 6-14 Figure 6-14 Figure 6-14 Result of "show serial" CLI Command Result of "show serial" CLI Command Result of "show serial" CLI Command Result of "show serial" CLI Command

configure mac access control

configure mac access control configure mac access control configure mac access control
setup mac (address) access control table setup mac (address) access control table
setup mac (address) access control table setup mac (address) access control table
[Device Name]>set macaclstatus enable
[Device Name]>set macacloptype <passthru, block>
[Device Name]>reboot 0
add an entry to the mac access control table add an entry to the mac access control table
add an entry to the mac access control table add an entry to the mac access control table
[Device Name]>set macacltbl <index> macaddr <MAC Address, such as 00:12:34:56:78:ab>
status enable
[Device Name]>show macacltbl
disable or delete an entry in the mac access control table disable or delete an entry in the mac access control table
disable or delete an entry in the mac access control table disable or delete an entry in the mac access control table
[Device Name]>set macacltbl <index> status <disable/delete>
[Device Name]>show macacltbl
NOTE:
For larger networks that include multiple WL520 devices, you may prefer to maintain this list on a centralized location
using the RADIUS parameters (see
description description description description
All management channels disabled
Ethernet only enabled
Wireless A only enabled
Wireless B only enabled
All management channels enabled
Set RADIUS Parameters).
Other Network Settings
6-20