Set Http Interface Management Services; Configure Serial Port Interface Settings; Other Security Configuration Settings; Configure Your Mac (Address) Access Control Table - HP WL520 User Manual

set http interface management services

set http interface management services
set http interface management services set http interface management services
1. In the Web Interface, click the
2. Choose the sub-tab.
Services Services
Services Services
3. For each service, there is a list of associated settings. From the drop-down menu, select which physical interface(s) can be
used to manage the WL520 device using the Web interface. For example, to allow Web configuration via the Ethernet
network only, set HTTP Interface Bitmask HTTP Interface Bitmask HTTP Interface Bitmask HTTP Interface Bitmask to Ethernet
— Disabled (all interfaces)
— Ethernet only enabled
— Wireless A only enabled
— Wireless B only enabled
— All Interfaces enabled
4. Enter the HTTP communication port number. Default is 80.
NOTE:
See Configuring Management Service Interfaces
that can be configured from the Services screen.

configure serial port interface settings

configure serial port interface settings configure serial port interface settings configure serial port interface settings
The serial port interface on the WL520 device is enabled at all times. You can set the following parameters as needed:
– Baud Rate Baud Rate . Select the serial port speed (bits per second). Choose between 2400, 4800, 9600, 19200, 38400, or 57600;
Baud Rate Baud Rate
the default Baud Rate is
– . Select either
Flow Control Flow Control
Flow Control Flow Control
NOTE:
To avoid unexpected performance of your WL520, leave the setting Flow Control to its default value (none) unless you
are sure what this setting should be.

other security configuration settings

other security configuration settings
other security configuration settings other security configuration settings
Control access to the WL520 device using MAC Address authentication, WEP encryption, or 802.1x security settings.

configure your mac (address) access control table

configure your mac (address) access control table
configure your mac (address) access control table configure your mac (address) access control table
Figure 2-20 Figure 2-20 Figure 2-20 Figure 2-20 Security Configuration Screen - MAC Authentication Security Configuration Screen - MAC Authentication Security Configuration Screen - MAC Authentication Security Configuration Screen - MAC Authentication
button and select the
Configure Configure Configure Configure
Ethernet Ethernet Ethernet. The available configuration options are:
for information on the SNMP, Telnet, and other HTTP parameters
.
9600 9600 9600 9600
(default) or (software controlled) data flow control.
None None Xon/Xoff Xon/Xoff
None None Xon/Xoff Xon/Xoff
Other Security Configuration Settings
tab.
Management Management Management Management
2-20