System Parameters; Inventory Management Information; Network Parameters; Dhcp Server Parameters - HP WL520 User Manual

system parameters

system parameters
system parameters system parameters
name name name name
System
Name
Location
Contact Name
Contact E-mail
Contact Phone
FLASH Backup Interval
Flash Update
System OID
Descriptor
Up Time
Emergency Restore to defaults

inventory management information

inventory management information inventory management information inventory management information
name name name name
System Inventory Management Subgroup
Component Table
Component Interface Table
NOTE:
The inventory management commands display advanced information about the WL520's installed components. You
may be asked to report this information to a technical representative if you contact customer support.

network parameters

network parameters network parameters network parameters
name name name name
Network
IP Configuration
IP Address
IP Mask
Default Router IP Address
Default TTL
Address Type
NOTE:
The IP Address Assignment Type (ipaddrtype) must be set to static before the IP Address (ipaddr), IP Mask (ipmask) or
Default Gateway IP Address (ipgw) values can be entered.

dhcp server parameters

dhcp server parameters dhcp server parameters dhcp server parameters
name name name name
type type type type values values values values
Group N/A
DisplayString User Defined
DisplayString User Defined
DisplayString User Defined
DisplayString User Defined
DisplayString User Defined
max 254 characters
Integer 0 - 65535 seconds
0
1
DisplayString N/A
DisplayString System Name, flash version,
S/N, bootloader version
Integer dd:hh:mm:ss
dd – days
hh – hours
mm – minutes
ss – seconds
Resets all parameters to default
factory values
type type type type values values values values
N/A
Subgroup N/A
Subgroup N/A
type type type type values values values values
Group N/A
Group N/A
IpAddress User Defined
IpAddress User Defined
IpAddress User Defined
Integer User Defined
64 (default)
Integer static
dynamic (default)
type type type type values values values values
Parameter Tables
access access access access cli parameter cli parameter cli parameter cli parameter
R system
RW sysname
RW sysloc
RW sysctname
RW sysctemail
RW sysctphone
RW sysflashbckint
RW sysflashupdate
R sysoid
R sysdescr
R sysuptime
RW sysresettodefaults
Note: You must enter the
following command twice to
reset to defaults:
sysresettodefaults 1 sysresettodefaults 1 sysresettodefaults 1 sysresettodefaults 1
access access access access cli parameter cli parameter cli parameter cli parameter
R sysinvmgmt
R sysinvmgmtcmptbl
R sysinvmgmtcmpiftbl
access access access access cli parameter cli parameter cli parameter cli parameter
R network
R ip (Note: The network network and ip ip ip ip
network network
parameters display the same
information)
RW ipaddr
RW ipmask
RW ipgw
RW ipttl
RW ipaddrtype
access access access access cli parameter cli parameter cli parameter cli parameter
set set set set
6-24