Managing Ip Access - HP WL520 User Manual

managing ip access

managing ip access
managing ip access managing ip access
Figure 4-8 Figure 4-8 IP Access Table Configuration Screen IP Access Table Configuration Screen
Figure 4-8 Figure 4-8 IP Access Table Configuration Screen IP Access Table Configuration Screen
The Management IP Access table is used to specify a station or stations that are authorized to manage the WL520 device
through available management services (SNMP, HTTP [Web], and Telnet [CLI]). To configure this table, click Add
following parameters:
– . Enter the IP Address for the management station.
IP Address IP Address IP Address IP Address
– IP Mask IP Mask . Enter a mask that will act as a filter to limit access to a range of IP Addresses.
IP Mask IP Mask
– . Enter an optional comment such as the station name.
Comment Comment Comment Comment
NOTE:
The IP mask 255.255.255.255 would authorize the single station defined by the IP Address to configure the Access
Point device. The Access Point device would ignore commands from any other IP address. In contrast, the IP mask
255.255.255.0 would authorize anyone on the subnet shared by the IP Address
To edit or delete an entry, click
pull-down menu.
anyone on the subnet shared by the IP Address to configure the Access Point device.
anyone on the subnet shared by the IP Address anyone on the subnet shared by the IP Address
. Edit the information, or select
Edit Edit Edit Edit
Management Settings
, , or from the
Enable Enable Enable Enable Disable Disable Disable Disable Delete Delete Delete Delete
Add and set the Add Add
Status
4-9