Dhcp Ip Pool Table Settings; Link Integrity Settings; Target Ip Address Table Settings - HP WL520 User Manual

dhcp ip pool table settings

dhcp ip pool table settings
dhcp ip pool table settings dhcp ip pool table settings
To add an entry, click , and then specify the start and end IP Address.
Add Add Add Add
– . Enter the starting IP Address for this IP Pool Table.
Start IP Address Start IP Address Start IP Address Start IP Address
– . Enter the ending IP Address for this IP Pool Table.
End IP Address End IP Address
End IP Address End IP Address
– . Enter related information.
Comment Comment Comment Comment
–
Default Lease Time (optional) Default Lease Time (optional)
Default Lease Time (optional) Default Lease Time (optional)
renews IP Addresses without client notification. Default is 86400 seconds.
–
Maximum Lease Time (optional) Maximum Lease Time (optional)
Maximum Lease Time (optional) Maximum Lease Time (optional)
renews IP Addresses without client notification. Default is 86400 seconds.
– . Shows enabled/disabled status.
Status Status Status Status
To edit or delete an entry, click

link integrity settings

link integrity settings link integrity settings link integrity settings
This feature checks the link between the WL520 and connected network server(s). If the link goes down then the client will
connect to another WL520 in your network that still communicates with the server.
NOTE:
This feature is only applicable to 2.4 GHz (802.11b) cards.
Figure 4-2 Figure 4-2 Figure 4-2 Figure 4-2 Link Integrity Configuration Screen Link Integrity Configuration Screen Link Integrity Configuration Screen Link Integrity Configuration Screen
– . Place a check mark in the box provided to activate the Link Integrity feature.
Enable Link Integrity Enable Link Integrity Enable Link Integrity Enable Link Integrity
– Poll Interval Poll Interval . Set the interval (minimum 500ms and in increments of 500ms) between polls.
Poll Interval Poll Interval
– . Set the number of times a poll should be retransmitted before the link is considered down.
Poll Retransmissions Poll Retransmissions Poll Retransmissions Poll Retransmissions

target ip address table settings

target ip address table settings
target ip address table settings target ip address table settings
To add an Target IP Address entry, click
– . Enter the IP Address
Target IP Address Target IP Address Target IP Address Target IP Address
– . Enter related information.
Comments Comments
Comments Comments
– . Shows enabled/disabled status. A disabled status only means that the WL520 is not checking the link, for example,
Status Status Status Status
when the network server is being serviced.
To edit or delete an entry, click
- the default time value for clients to retain the assigned IP Address. DHCP automatically
- the maximum time value for clients to retain the assigned IP Address. DHCP automatically
. Edit the information, or select
Edit Edit Edit Edit
Add Add , and then specify the IP Address of the servers you want to check.
Add Add
. Edit the information, or select
Edit Edit Edit Edit
, , or from the
Enable Enable Enable Enable Disable Disable Disable Disable Delete Delete Delete Delete
or from the
Enable Enable Enable Enable Disable Disable Disable Disable
Status
Network Settings
pull-down menu.
Status
pull-down menu.
4-3