Set And Change Passwords - HP WL520 User Manual

An Encryption Key is composed of the secret key (entered by the user) and a 24-bit Initialization Vector (IV). Some
products report an Encryption Key Size with the IV and some report a Key Size without the IV. Therefore, 64-bit
encryption is also referred to as "40-bit" encryption (without the IV), 128-bit encryption is also referred to as "104-
bit" encryption (without the IV), and 152-bit encryption is also referred to as "128-bit" encryption (without the IV).
5. Select a key to use for WEP encryption.
NOTE:
Client stations must have the same encryption key to be able to communicate with the WL520 device.
6. For 802.11b only, set
and the proper keys configured from communicating with the network.
7. Select OK OK .
OK OK
See Change your Wireless Interface Settings
802.1x Security Mode for additional security information.

set and change passwords

set and change passwords
set and change passwords set and change passwords
Figure 2-9 Figure 2-9 Fig re 2-9 Figure 2-9 u Setting Interface Passwords Setting Interface Passwords Setting Interface Passwords Setting Interface Passwords
1. In the Web Interface, click the
2. Change the default passwords for the SNMP, Telnet/CLI, and HTTP interfaces.
SNMP Read Password, Confirm SNMP Read Password, Confirm SNMP Read Password, Confirm SNMP Read Password, Confirm
password is "public".
SNMP Read/Write Password, Confirm SNMP Read/Write Password, Confirm
SNMP Read/Write Password, Confirm SNMP Read/Write Password, Confirm
default password is "public".
Telnet (CLI) Password, Confirm Telnet (CLI) Password, Confirm Telnet (CLI) Password, Confirm Telnet (CLI) Password, Confirm
password is "public".
HTTP (Web) Password, Confirm HTTP (Web) Password, Confirm HTTP (Web) Password, Confirm HTTP (Web) Password, Confirm
password is "public".
NOTE:
For security purposes we recommend changing ALL
access to your network devices to authorized personnel. We also recommend that you document your WL520
configuration using the work sheets provided for you in
your password settings, you can always perform the .
to
Deny Non-Encrypted Data Deny Non-Encrypted Data Deny Non-Encrypted Data Deny Non-Encrypted Data Enable Enable Enable Enable
for information on the rest of the wireless configuration parameters. Also,
Configure Configure button and select the
Configure Configure
. Enter each password in both the
. Enter the password in both the
. Enter the password in both the
. Enter the password in both the
changing ng ALL PASSWORDS ALL PASSWORDS from the default "public" immediately, to restrict
changing ch angi ALL PASSWORDS
if you want to prevent clients that do not have WEP enabled
Management Management tab.
Management Management
field and the
Read Password Read Password Read Password Read Password
Read Password Read Password
Read Password Re ad Pa sswor
field and the
Read Password Read Password Read Password Read Password
field and the
Read Password Read Password R ad Pa Re e ad Password ssword
PA SSWO RDS
Recording Your Configuration
IEEE
field. The default
Confirm Confirm Confirm Confirm
field and the field. The
Confirm Confirm
d Confirm Confirm
field. The default
Confirm Confirm Confirm Confirm
field. The default
Confirm Confirm Confirm Confirm
Settings. If you lose or forget
2-8