Setting Filters; Setting The Ethernet Protocol Filter - HP WL520 User Manual

setting filters

setting filters setting filters setting filters
Setting protocol filters through the Ethernet Protocol Filter, TCP/UDP Port Filter, and the Advanced Filtering interface can impact
the performance of your network by limiting the amount of unnecessary traffic received from unsupported protocols. In
addition, various filters can be set up through the Static MAC Address Table to control the interaction between network devices
and to control the types of protocol packets distributed by your network.
This section describes the Ethernet Protocol, Advanced, and TCP/UDP Port filtering options. See
information on the Static MAC address filter.

setting the ethernet protocol filter

setting the ethernet protocol filter setting the ethernet protocol filter setting the ethernet protocol filter
Use the Ethernet Protocol tab to set filters.
– Enable Ethernet Filter Status. Place a checkmark in the box provided to enable filtering. If disabled, then the Enable Ethernet Filter Status. Place a checkmark in the box provided to enable filtering. If disabled, then the Enable Ethernet Filter Status. Place a checkmark in the box provided to enable filtering. If disabled, then the Enable Ethernet Filter Status. Place a checkmark in the box provided to enable filtering. If disabled, then the WL520 will
not filter any of the Ethernet protocols listed in the Filter Table. not filter any of the Ethernet protocols listed in the Filter Table. not filter any of the Ethernet protocols listed in the Filter Table. not filter any of the Ethernet protocols listed in the Filter Table.
Ethernet Protocols listed in the Filter Table will pass through the bridge. If set to
Ethernet Protocols listed in the Filter Table.
Figure 4-10 Figure 4-10 Figure 4-10 Figure 4-10 Ethernet Filter Configuration Screen Ethernet Filter Configuration Screen Ethernet Filter Configuration Screen Ethernet Filter Configuration Screen
ethernet protocol filter table ethernet protocol filter table ethernet protocol filter table ethernet protocol filter table
This table is pre-populated with existing Ethernet Protocol Filters, however, you may enter additional filters by specifying the
appropriate parameters.
To add an entry, click
Add Add Add Add
– Protocol Number Protocol Number . Enter the protocol number. See
Protocol Number Protocol Number
protocol numbers.
– . Enter related information, typically the protocol name.
Protocol Name Protocol Name
Protocol Name Protocol Name
To edit or delete an entry, click
menu.
, and then specify the
Protocol Number Protocol Number Protocol Number Protocol Number
http://www.iana.org/assignments/ethernet-numbers
the information, or select
Edit and change Edit Edit Edit
If set to
Filter Operation Type. Filter Operation Type. Filter Operation Type. Filter Operation Type.
Block Block , the bridge will block enabled
Block Block
and a Protocol Name Protocol Name Protocol Name. Protocol Name
, or
Enable Enable, , , , Disable Enable Enable Disable Disable Disable Delete Delete Delete Delete
Setting Filters
Static MAC Address Filter for
will will will
, only the enabled
Passthru Passthru Passthru Passthru
for a list of
from the pull-down
Status
4-11