Table of Contents
Advertisement
Installation
SITE INSTALLATION
WARNING
Improper installation, alteration,
adjustment, service, cleaning, or
maintenance could result in property
damage, severe injury, or death.
Read and understand the installation,
operating and maintenance instructions
thoroughly before installing, servicing, or
operating this equipment.
INSTALLATION CODES & STANDARDS
The following codes and standards are required for
installation of this oven:
AIR SUPPLY, ELECTRICAL CONNECTIONS, WATER
CONNECTIONS, AND WASTE WATER DISCHARGE.
Installation shall comply with local codes required
for gas appliances. In the absence of local codes,
installation shall comply with the latest edition of:
•
USA: National Fuel Gas Code, ANSI Z223.1 (NFPA
54). And OSHA Regulations
•
Canada: Natural Gas and Propane Installation
Code, CAN/CSA-B149.1-15
•
EU: European Standard EN203
•
Australia/New Zealand: AS 5601
Adherence to code by a qualified installer is essential
for the following: gas plumbing, gas appliance
installation, commercial cooking ventilation, water
and plumbing.
WARNING
Electric shock hazard.
Perform lockout/tagout procedures before
cleaning or servicing this appliance.
8
MN-35947
•
Rev 12
11/16
Combitherm® CT PROformance™ and CT Classic Series Installation Manual
•
•
•
AVERTISSEMENT
Une installation, des modifications,
le réglage, l'entretien, le nettoyage ou
une maintenance inadéquats peuvent
endommager le matériel ou entraîner des
blessures graves ou mortelles.
Lisez attentivement et assimilez les
consignes d'installation, d'utilisation et
d'entretien avant d'installer, d'entretenir ou
d'utiliser ce matériel.
VENTILATION REQuIREmENTS
A steam ventilation hood is mandatory for the
operation of the oven. In addition, a single gas
Combitherm oven requires a minimum of 28 CFM
make-up air for both natural and propane gas.
Authorities having jurisdiction should be consulted
as to the requirements for this equipment with
respect to ventilation and fire extinguishing systems
to ensure conformity with any Federal, State, or local
installation codes.
See the section titled Gas Exhaust
SOuND pRESSuRE mEASuREmENTS
The A-weighted sound pressure level without
ventless hood operating is less than 70dBA.
notICe: ALWAYS remove the electronic control boards
BEFORE welding any stainless steel components
on this appliance. Failure to do so will damage
the control boards and may void the warranty.
Advertisement
Table of Contents
