Table of Contents
Advertisement
35-11/16" (906mm)
41-7/16"
(1053mm)
B
A
D
26-3/16" (665mm)
"
28-3/4
(730mm)
1-11/16" (42mm)
Water reQUiremeNtS
TWO (2) COLD WATER INLETS - DRINKING QUALITY
ONE (1) TREATED WATER INLET:
ONE (1) UNTREATED WATER INLET: 3/4" NPT*
LINE PRESSURE: 30 psi minimum dynamic and 90 psi maximum static (200 to 600 kPa)
WATER DRAIN: 1-1/2" (40mm)
.
MATERIALS MUST WITHSTAND TEMPERATURES UP TO
VENT
cLearaNce reQUiremeNtS
LEFT: 0" (0mm)
0" (0mm)
RIGHT:
NON-COMBUSTIBLE SURFACES
TOP: 20" (508mm)
FOR AIR MOVEMENT
4" (102mm)
BACK:
4-5/16" (109mm)
iNStaLLatioN reQUiremeNtS
• Oven must be installed level.
• Water supply shut-off valve and back-flow preventer when required by local code.
eLectricaL - ctp6-10e
(NO CORD, NO PLUG, DEDICATED CIRCUIT REQUIRED)
VOLTAGE
PH
HZ
AWG
208 – 240
1*
50/60
6
208 – 240
3
50/60
8
380 – 415
3
50/60
8
440 – 480
3*
50/60 10 – 8
*ELECTRICAL SERVICE CHARGE APPLIES
WeiGht
NET
524 lbs
EST
SHIP
608 lbs*
Ship DimeNSioNS
58" x 45" x 51"*
(L x W x H)
(1473mm x 1143mm x 1295mm)*
*
DOMESTIC GROUND SHIPPING INFORMATION
FACTORY FOR EXPORT WEIGHT AND DIMENSIONS
14
MN-35947
# 4 2 5 - 0 3 / 1 6
•
A= UNTREATED WATER
B= TREATED WATER
C= ELECTRICAL
D= WATER DRAIN
41-7/16"
(1053mm)
B
A
D
C
"
2-5/16" (58mm)
28-3/4
(730mm)
1-11/16" (42mm)
3-5/16" (84mm)
IP X5
3/4" NPT*
* Both inlets can be from same 3/4" source.
Divide using a manifold. Run one side through
treatment device before running to oven.
CONNECTION WITH A
VERTICAL VENT TO EXTEND ABOVE THE EXHAUST
200°F (93°C).
18" (457mm)
RECOMMENDED SERVICE ACCESS
2" (51mm)
DOOR SWING OR
COMBUSTIBLE SURFACES
BOTTOM: 5-1/8" (130mm)
FOR LEGS, AIR INTAKE
OPTIONAL PLUMBING KIT
• Hood installation is required.
ECO
STANDARD
CONNECTION
AMPS
kW
L1, L2/N, G
37.9 – 43.8
7.9 – 10.5
L1, L2, L3, G
21.9 – 25.3
7.9 – 10.5
L1, L2, L3, N, G
13.4 – 14.6
9 – 10.5
L1, L2, L3, G
11.6 – 12.6
9.1 – 10.5
paN capacity
FULL–SIZE:
238 kg
GN 1/1:
276 kg*
HALF–SIZE SHEET
**
:
proDUct capacity
PRODUCT MAXIMUM
VOLUME MAXIMUM
.
CONTACT
.
Rev 12
11/16
•
•
d u E t o o n g o i n g p r o d u c t i m p r o v E m E n t
6.10 ELEC OVER 10.18 ELEC: 1850mm x 1111mm x 1150mm
6.10 ELEC OVER ASC-4E: 1877mm x 1111mm x 1182mm
6.10 ELEC ON 28" STAND: 1727mm x 907mm x 995mm
A= UNTREATED WATER
B= TREATED WATER
C= ELECTRICAL
6-11/16" (168mm)
D= WATER DRAIN
E= OPTIONAL ELECTRICAL
A, B, D
C - at bottom
of oven
B
A
D
(A, B) 2-5/16" (58mm)
(D) 3-5/16" (84mm)
(C, E) 6-3/8" (162mm)
39-1/4" (996mm)
DimeNSioNS: H x W x D
EXTERIOR:
34-1/2" x 35-11/16" x 41-7/16" (876mm x 906mm x 1053mm)
EXTERIOR WITH RECESSED DOOR:
34-1/2" x 40-11/16" x 41-7/16" (876mm x 1033mm x 1053mm)
INTERIOR:
Water QUaLity StaNDarDS
It is the sole responsibility of the owner/operator/purchaser of this equipment
to verify that the incoming water supply is comprehensively tested and if
required, a means of "water treatment" provided that would meet compliance
requirements with the published water quality standards shown below.
Non-compliance with these minimum standards will potentially damage this
equipment and/or components and void the original equipment manufacturer's
warranty. Alto-Shaam recommends using OptiPure
products to properly treat your water.
Total Dissolved Solids (tds)
**PROpower™
OPTION
BREAKER
AMPS
kW
BREAKER
40 – 50
44.2 – 51.3
9.2 – 12.3
45 – 60
25 – 30
28.4 – 32.6
9.2 – 12.3
30 – 35
16
20.3 – 22.1 10.3 – 12.3
15
15 – 16.7
10.4 – 12.3
15 – 20
**NO-COST OPTION ON ELECTRIC MODELS
STANDARD MODEL
20" x 12" x 2-1/2"
530 x 325 x 65mm
18" x 13" x 1"
**ON WIRE SHELVES ONLY. ADDITIONAL WIRE SHELVES REQUIRED FOR MAXIMUM CAPACITY
Combitherm® CT PROformance™ and CT Classic Series Installation Manual
,
•
s p E c i f i c a t i o n s a r E s u b j E c t t o c h a n g E w i t h o u t n o t i c E
6.10 ELEC OVER ASC-4E: 1877mm x 1111mm x 1182mm
6.10 ELEC ON 28" STAND: 1727mm x 907mm x 995mm
CTP6-10E
ElEctric boilEr
6-11/16" (168mm)
A, B, D
C - at bottom
of oven
B
A
E
D
C
20-1/2" x 16-1/4" x 28-1/16" (520mm x 411mm x 712mm)
Contaminant
Inlet Water Requirements
Free Chlorine
Less than 0.1 ppm (mg/L)
Hardness
30-70 ppm
Chloride
Less than 30 ppm (mg/L)
pH
7.0 to 8.5
Silica
Less than 12 ppm (mg/L)
50-125 ppm
WITH COMBISMOKER
ECO
STANDARD
AMPS
kW
BREAKER
40.4 – 46.6 8.4 – 11.2
40 – 50
24.4 – 28.1 8.4 – 11.2
25 – 30
32
16.1 – 17.5 9.6 – 11.2
16 – 32
12.9 – 14.1 9.6 – 11.2
15
WITH COMBISMOKER
Seven (7)
Seven (7)
Seven (7)
72 lb (33 kg)
45 quarts (57 liters)
.
-
frEE
39-1/4" (996mm)
®
[www.optipurewater.com]
®
OPTION
**PROpower™
OPTION
AMPS
kW
BREAKER
46.7 – 54.1 9.7 – 13
50 – 60
30.9 – 35.5 9.8 – 13
35 – 40
22.9 – 25
10.9 – 13
32
16.3 – 18.2
11 – 13
20
®
OPTION
Six (6)
Six (6)
Seven (7)
.
-
.
w w w
a l t o
s h a a m
c o m
Advertisement
Table of Contents
