Table of Contents
Advertisement
Installation
S I T E I N S T A L L AT I O N
WARNING
To prevent serious injury, death, or property damage:
• Always keep appliance on top of a pallet when using a
fork li or a pallet li truck to move appliance.
• Always use a su icient number of trained and
experienced workers to place the appliance on floor,
stand, or counter.
INSTALLATION
To ensure proper operation, the installation of this
oven must be completed by qualified technicians in
accordance with the instructions provided in this
manual. Failure to follow the instructions provided may
result in damage to the oven, building, or cause personal
injury to personnel.
NO T ICE: To prevent PROPERTy dAMAGE:
Check the dimensions of the doorways and
aisles before attempting to move the oven
and pallet to the installation site.
do not tilt the oven. Transport the oven in
an upright and level position only.
Slide the preheat strip into place before
using a forklift or pallet jack in between
the trolley guides to avoid damaging the
preheat strip when lifting.
LIfTINg INSTRuCTIONS
Remove banding before lifting. Lift the unit from
the front only, never from the side.
Adjust the forks so that they do not damage any
of the components under the unit. Note that the
control side of the oven is the heaviest portion.
Lift the unit just high enough to remove the
wooden pallet. Lower the unit as close to the
floor as possible and no more than 2" (50mm)
above the floor. Secure hoses and dangling cords
to avoid tangling or damage. When moving the
unit, drive slowly, keep it low to the ground, and
use extreme caution.
38
MN-35947
•
grease Collection pump
Rev 12
11/16
Combitherm® CT PROformance™ and CT Classic Series Installation Manual
•
•
•
depth of forks is critical for units
equipped with grease collection to avoid
damaging the pump
components
protrude below
oven
Advertisement
Table of Contents
