Table of Contents
Advertisement
g R E A S E C O L L E C T I O N I N S T A L L AT I O N ( I f E Q u I p p E D W I T H T H I S O p T I O N )
Hose guide
Thumb
bracket
screw
A
Grease Collection Hose
•
Grease Collection Hose Assembly is attached to the oven in
the back.
•
The hose guide bracket can be attached on either the le
side or the right side toward the back. Placement on the
le side is recommended whenever possible. Thumb
screws are in position for this purpose. Remove thumb
screws, position hose guide bracket and secure screws
(
). Thread grease hose through the guide.
pHoto a
•
The hose hanger bracket can be attached on either the
le side or the right side toward the front of the oven.
Placement on the le side is recommended whenever
possible. Remove the plastic protective lm from the
bracket (
,
). Pan head screws are in position beneath
pHoto b
c
the oven for this purpose. For stacked con gurations,
always place the hanger bracket on bottom of the top
oven. Remove pan head screws and washers (
position hose hanger bracket on either side of the oven and
secure screws and washers (
is used to secure the grease collection hose while changing
grease collection containers.
•
Place Grease Collection Containers inside the tray of the
Mobile Grease Collection Cart. Roll into place next to the
oven and apply the caster brake.
•
❖
Loosen vent cap on container. Pull out the Grease
Collection Hose Assembly from the back of the unit.
Remove collection container ll cap (
•
Screw Grease Collection Hose Assembly on to collection
container until snug.
•
Turn ball valve handle to the ON position.
MN-35947
•
Hose hanger bracket with film
B
D
pHoto d
,
). The hanger bracket
pHoto e
f
).
pHoto g
Rev 12
11/16
Combitherm® CT PROformance™ and CT Classic Series Installation Manual
•
•
),
Vent
Grease
Collection
Cap
Container
Installation
Hose hanger bracket
C
E
F
On/O Ball Valve
Recommended
Capacity
•
G
Container
Fill Cap
57
Advertisement
Table of Contents
