Table of Contents
Advertisement
E L E C T R I C A L K I T I N S T A L L AT I O N – 5 0 H z
International
Applications
Appliance side
B
B
1
A
Power supply side
Discard the cover plate if applicable.
3
Position and attach the support plate (x).
x
6
Strip the wires, then connect them to the terminal strip.
Note: Illustrations are representative only. Your appliance may vary.
L1 L2/N
BK WH GR
MN-35947
•
1
A
2
Cut threads into nut before installing fitting.To do so, apply a
light lubricant and thread nut on and off fitting.
B
1
* For 1-phase appliances remove red wire and orange wire.
2
Remove enough cable covering so that wires reach the terminal strip.
Depending on the application, install the straight or elbow fitting to the cable.
Install the fitting/wiring to the appliance.
4
1-1/2" NPT and smaller bushings through the
bottom, all others through the back.
x
Installation point for 1-1/2" NPT and smaller 90º bushings.
x
PE
Rev 12
11/16
Combitherm® CT PROformance™ and CT Classic Series Installation Manual
•
•
1
2
3
1
2*
3
4
5
L1
BK
12mm
Installation
Cut threads into nut before installing fitting.
To do so, apply a light lubricant and thread
nut on and off fitting.
B
2
2*
3
* For 1-phase appliances remove red wire and orange wire.
Route the wires.
5
Keep wires away from hot surfaces such as:
water tank, drain pipe, motor, edges of sheet
metal, vent pipes, or other appliances.
PE
L2
L3
N
RD
OR
WH GR
L1
L2 L3
N
PE
BK
RD OR WH
GR
1
4
5
43
•
Advertisement
Table of Contents
