Backlighting setting (LIGHT SET)
This function allows backlighting setting of the
dashboard.
To display the function, go into the menu "LIGHT
SET" page.
Holding RESET button (14, fig. 14) pressed for 3
seconds in this menu page gives access to the setup
mode and the following pages are displayed, one
after the other.
Page 1 - "LIGHT MAX" set up:
Within this page backlighting is set to maximum
power; press button (1, fig. 19) "▲" to go to page 2.
Page 2 - "LIGHT MID" set up:
Within this page backlighting is reduced by
approximately 30% compared to its maximum
power; press button (1, fig. 19) "▲" to go to page 3.
Page 3 - "LIGHT MIN" set up:
Within this page backlighting is reduced by
approximately 70% compared to its maximum
power; press button (1, fig. 19) "▲" to go to page 1.
Press RESET for 3 sec.
Press "▲"
Press "▲"
Press RESET for 3 sec.
Press RESET for 3 sec.
Press "▲"
Press RESET for 3 sec.
fig. 30
49