When the LAP function is set disabled on the menu,
the current "lap" is not stored.
If the LAP function is active and the dashboard is
suddenly turned off (Key-Off), the LAP function will
be automatically disabled (even if the lap timer was
active, the current "lap" is not stored).
If the time is never "stopped", it will roll over upon
reaching 9 minutes, 59 seconds and 99 hundredths;
the lap timer starts counting from 0 (zero) and will
keep running until the function is disabled.
If, however, the LAP function is switched on and the
memory has not been cleared, but fewer than 30 laps
have been saved (e.g. 18 laps), the Dashboard will
store any remaining laps until the memory is full (in
this case, it will store an additional 12 laps).
This function only displays lap times; but other data
are also saved (MAX rpm, rev limiter if reached) for
viewing at a later date in the Lap Memory function.
52
press LAP (1st time)
press LAP (2nd time)
press LAP (from 32nd time up, except
time RESET)
Press "
" for 10 sec.
Press "
" for 10 sec.
Press "
" for 10 sec.
fig. 32