Chapter 12: Install The Fixed Sidelite; Section 12.1: Secure The Fixed Sidelite To The Door Frame - Nabco GT1175 Installation Manual

GT1175 Standard Slide Doors Installation Manual; with U30 Control
P/N C-00105
7. Close and then break open the Swing door to test fit for both Ball Detents.
a. To adjust the fit, increase the size of the hole and countersink.
b. Do Not over-drill the hole. If hole is overdrilled the Threshold will need to be replaced.
c. For additional travel remove the Ball Detent Bracket to lower or raise the Ball Detent.
CHAPTER 12: INSTALL THE FIXED SIDELITE
DN 1703
SECTION 12 .1: Secure the Fixed Sidelite to the Door Frame
1. Locate (2) Cut Outs on the side of the Pivot Stile. Align and then slide the Fixed Sidelite until (2) Mounting Brackets
(preinstalled on the Pivot Jamb Tube) can be seated inside each Cut Out.
2. Slide the Fixed Sidelite towards the Interior of the Building until both Mounting Brackets butt up against the inside wall of
the Pivot Stile.
Jamb Tube Moun ng Bracket
3. Locate (1) cut out at the top of Strike Stile. Align and then slide the Fixed Sidelite until (1) mounting bracket (preinstalled
under the Bottom Lip of Header) can be seated inside the Cut Out.
Moun ng Bracket
DN 0862
4. Snap a chalk line between Jamb Tubes in front of Sidelite Panel. If the Sidelite Panel is flush to the chalk line, it is square.
5. Secure the Fixed Sidelite Panel to all (3) Mounting Brackets with 1/4-20 x 1/2 inch Flat Head Screws.
DN 0624
20 of 56
Fixed Sidelite
Header Moun ng Bracket
(Inside Ver cal Mullion)
1/4-20 x 1/2"
Flat Head Screw
Cut Out
Strike S le
Jamb Tube
Figure 42 Only the Slide Door has Breakout Capabilities
Figure 43 Slide Mounting Block into Top Rail
Figure 44 Slide Mounting Bracket into Cut Out
Chalk Line
Fixed Panel
www.NabcoEntrances.com
Slide Door
1/4-20 x 1/2"
FlatHead Screw
Cutout Clearance
Jamb Tube
Moun ng Bracket
Jamb Tube
Figure 45 Ensure Fixed Panel is Square
Rev 5-17-19
DN 0863