Installing The Serial Wan Cable; Connecting A Smartnode 4830 Series Device To A Hub - Patton electronics SmartNode 4830 Series Getting Started Manual

SmartNode 4830 Getting Started Guide
SmartNode: RJ-45, male
Tx+ 1
Tx- 2
Rx+ 3
Rx- 6
Figure 15. Connecting a SmartNode 4830 Series device to a hub

Installing the serial WAN cable

The SmartNode 4830 Series is available with the following serial interfaces):
• DSL (RJ11)—See section
face cable
• V.35 (DB-25)—See section
interface cable
• X.21 (DB-15)—See section
interface cable
• T1/E1 (RJ48C connectors)—See section
on installing the twisted pair cable
• E1 (Dual coaxial connectors)—See section
installing the coaxial cables
Installing the VoIP IAD
Straight-through cable
"Installing the DSL interface cable"
"Installing the V.35 interface cable"
"Installing the X.21 interface cable"
"Installing the T1/E1 twisted pair cables"
"Installing the E1 dual coaxial cables"
3 • Hardware installation
Hub
Hub/switch: RJ-45, male
1 Rx+
2 Rx-
3 Tx+
6 Tx-
on page 37 for details on installing the inter-
on page 37 for details on installing the
on page 38 for details on installing the
on page 39 for details
on page 40 for details on
36