Ports Descriptions; Reset Button Behavior; Rear Panel Ports - Patton electronics SmartNode 4830 Series Getting Started Manual

SmartNode 4830 Getting Started Guide

Ports descriptions

The SmartNode 4830 Series rear-panel ports are described in
Port
10/100 Ethernet Rear panel RJ-45 connectors (see
ETH 0/0 & ETH 0/1
Analog voice port, Rear panel FXS RJ-11(6 position, 4 wire) connectors (see
FXS
Analog voice port, Rear panel FXO RJ-11(6 position, 4 wire) connectors that connect the product with an
FXO
V.35 or X. 21 Serial Rear Panel Female DB-25 or DB-15 socket provides a V.35 or X.21 serial interface for
(option)
T1/E1 Rear panel E1
(option)
G.SHDSL/ADSL port Rear panel Provides up to 5.7 Mbps (G.SHDSL) or 8 Mbps (ADSL) symmetrical
(option)
Power Rear panel The gateway is available in a DC or AC power input version (see
Console Front panel Used for service and maintenance, the Console port (see

Reset button behavior

For those SmartNode devices that have a Reset button on the rear panel, its behavior is as follows:
• To restart the unit with the current startup configuration—Press for less than 1 second and release the Reset
button. The SmartNode will restart with the current startup configuration.
• To restart the unit with factory default configuration—Press the Reset button for 5 seconds until the Power
LED starts blinking. The unit will restart with factory default configuration.
• To restart the unit in bootloader mode (to be used only by trained SmartNode technicians)—Start with the
unit powered off. Press and hold the Reset button while applying power to the unit. Release the Reset button
when the Power LED starts blinking so the unit will enter bootloader mode.
SmartNode Model 4830 Series Overview
Table 2. Rear panel ports
Location
Ethernet device (e.g., a cable or DSL modem, LAN hub or switch).
connect the product with an analog terminal (a telephone, for example)
FXO port. EuroPOTS support (ETSI EG201 188).
analog line (FXS port). EuroPOTS support (ETSI EG201 188).
leased-line connection to a WAN at rates up to 2 Mbps.
G.703/G.704 with HDB3 or AMI encoding. RJ-48C and dual coax-
—
ial connectors.
T1 ANSI T1.403 & AT&T TR54016 with AMI coding/D4 framing or
—
B8ZS coding/ESF framing. RJ-48C connector.
throughput, supporting ATM QoS. Supports multiple PVC and DSLAM
interoperability.
The DSL LEDs are located on either side of the DSL port. ACT (when lit or
blinking) shows Activity, and LINK (when lit) shows that the DSL port is
connected.
), labeled 100–240 VAC, 50/60 Hz, 200 mA
figure 6
an RS-232 RJ-45 connector, connects the product to a serial terminal such as a
PC or ASCII terminal (also called a dumb terminal).
table 2.
Description
on page 18) that connect the product to an
figure 3
1 • General information
on page 18) that
figure 3
on page 23),
figure 7
22