Installing The Ethernet Cable; Analog Fxo Connection; Ethernet 10/100Base-T (Rj-45) Port Pin-Outs - Patton electronics SmartNode 4830 Series Getting Started Manual
Analog voip integrated access device
Hide thumbs
Also See for SmartNode 4830 Series:
- Quick start manual (13 pages) ,
- Quick start manual (13 pages)
Table of Contents
Advertisement
SmartNode 4830 Getting Started Guide
Installing the Ethernet cable
The SmartNode 4830 Series has automatic MDX (auto-cross-over) detection and configuration on the Ether-
net ports. Any of the two ports can be connected to a host or hub/switch with a straight-through wired cable
(see
figure
15). Ethernet devices (10Base-T or 100Base-T) are connected to the SmartNode's Ethernet ports
(see
table 6
for port pin-out listing) via a cable terminated with RJ-45 plugs.
Note
Installing the VoIP IAD
RJ-11, male
Ring (-) 3
Tip (+) 4
Figure 14. Analog FXO connection
Table 6. Ethernet 10/100Base-T (RJ-45) port pin-outs
Pin
1
2
3
6
Pins not listed are not used.
Signal
TX+
TX-
RX+
RX-
3 • Hardware installation
PSTN
wall plate
RJ-11, male
3 Ring (-)
4 Tip (+)
35
Advertisement
Table of Contents
