Reset All Settings; Inactive-Time Scheduler - Response CENTURION SCOUT Owner's Manual

RESET ALL SETTINGS

Press and hold SYSTEM ARMED/DISARMED key until verbal confirmation to reset SCOUT
to manufacturer settings. This will change all System Configurations back to default settings and
will clear all inactive times.
Note: To perform a system reboot, press and hold the reset button for two seconds (reference
page 3 – Reset Button).

INACTIVE-TIME SCHEDULER

Note: System does not automatically adjust for Daylight Savings Time.
Allows user to create a weekly schedule for all sensors, (excluding Duress Buttons and Bill
Traps), to be inactive. Duress Buttons and Bill Traps linked to the system will not be
affected by inactive times. During inactive-times, system will process duress button and bill
trap activations and ignore all other sensor activations.
Set an inactive-time:
1) Pres DAY/TIME key and confirm/correct day and time to the closest half-hour by the
active LED. To reset day and time, press the current day-of-the-week key and press the
BEGIN TIME key repeatedly until the LED at the half-hour mark closest to the current
time is lit. Press DAY/TIME key to confirm.
2) Press day-of-the-week key. Press the BEGIN TIME key to the desired start time of the
period you want sensors to be inactive on that day. Press END TIME key repeatedly until
LEDs between start time and desired end time of the inactive period are lit. Note: One or
two time periods can be selected per day. System will be inactive during periods
indicated by active LEDs.
3) When inactive time scheduling is complete, press day-of-the-week key to confirm.
4) Lit LEDs will indicate which days currently have an inactive time scheduled.
5) Repeat steps 2 and 3 for every day inactive times are needed.
6) To delete all inactive times for a specific day, press day-of-the-week key and press
RESET key. Repeat, to delete inactive times for multiple days. To delete all inactive
times for all days follow "RESET ALL SETTINGS" instructions.
To have the system inactive over night, the times will need to be bridged together between two
days. This is done by having the end time on the first day at 2400 and the start time on the
following day at 0001.
www.response-technologies.com - 11 -
Section 4
System Configuration
©Response Technologies, Ltd.
Revised: January 9, 2015