System Configuration - Response CENTURION SCOUT Owner's Manual

Section 5
Console Configuration
Message Repeat
Message Repeat field is used to set the desired amount of repeats (0-5) for the verbal message to
be annunciated upon sensor activation. Repeats are in addition to the standard message (one
repeat will play message twice).
Message Repeat Delay field is used to set the desired amount of time (0-10 seconds) between
message repeats.
Radio/Speaker Volume
Use the slide bar to set the desired output volume over the radio and/or speaker.

SYSTEM CONFIGURATION

Verbal Prompts
The system is programmed with verbal prompts to assist user with menu navigation. This
section enables the user to turn on/off verbal prompts (i.e. "SCOUT Armed", "Sensor Linked").
Battery Notify
The SCOUT is programmed with verbal notifications of internal back-up battery status (i.e.
"SCOUT battery low"). This section enables the user to turn on/off battery notifications. These
notifications are transmitted via user's radio system, paired cell phone, or speaker.
This notification is only for the internal battery of the main SCOUT unit; not sensors.
Entry/Exit Delay
Entry Delay field is used to set the delay (0-99 seconds) for all sensor activations. This delay is
intended to allow the user time to disarm the SCOUT prior to notification of sensor activation.
Exit Delay field is used to set the delay (0-99 seconds) for SCOUT to ARM from the time the
SYSTEM ARMED/DISARMED key is pressed. This delay is intended to allow the user time to
exit the premises before the SCOUT becomes active.
Output Relay
Select the output relay latch setting desired. The System Disarmed option will create a
continuous latch until the system is disarmed by the user. The Relay Latch Time option will
latch a single time for the amount of time specified.
www.response-technologies.com - 17 - ©Response Technologies, Ltd.
Revised: January 9, 2015