Record Message; Play Message; Speaker On/Off - Response CENTURION SCOUT Owner's Manual

RECORD MESSAGE

Record a location-specific message for sensor activation notification over radio, speaker, and/or
Bluetooth outputs.
To record message:
 Press the RECORD MESSAGE key and wait for the start tone.
 Speak the desired message 6 to 12 inches from the internal microphone located on the
front panel (reference page 3 – microphone).
 Press the RECORD MESSAGE key to end recording.
The desired message does not need to be repeated during recording. The system will repeat the
message once by default. Number of repeats and time between repeats are configurable with
provided Console software (see Console Configurations – Section 5).
Note: To reset message back to the default alarm message, press the RECORD MESSAGE key
once, and then immediately press the RECORD MESSAGE key again. Keypad beep will sound
once message has been reset.
Note: Message recording will time-out after 30 seconds if not saved. User will need to record
message again.

PLAY MESSAGE

Press PLAY MESSAGE key; current recorded message will play back.

SPEAKER ON/OFF

To turn built-in speaker (reference page 3 – speaker) ON or OFF as a sensor activation output
press the SPEAKER ON/OFF key; LED must be lit for speaker activation. When ON, the user
recorded message will play over built-in speaker during sensor activation.
Note: SPEAKER ON/OFF does not turn-off SCOUT verbal prompts. Verbal prompts can be
configured with provided Console software (see Console Configuration – Section 5).
www.response-technologies.com - 8 -
Section 4
System Configuration
©Response Technologies, Ltd.
Revised: January 9, 2015