Save/Arm; Reset Default Configuration; Date/Time; Inactive-Time Scheduler - Response CENTURION SCOUT Owner's Manual

Table of Contents

SAVE/ARM

Click the Save/Arm button to save all changes to the system and arm the system.

Click the Reset to Defaults button to change all settings back to factory default configuration.

Displays the SCOUT's current date and time.

To change Date/Time:

 Click on the Read from Computer button to display the computer's current Date/Time.

 Verify displayed time is correct.

 Click on the Set SCOUT Date/Time button to save displayed Date/Time to the system.

Note: System does not automatically adjust for Daylight Savings Time.

Note: Correct system day/time is important when using SCOUT Inactive-Time Scheduler (see

DATE/TIME above).

Allows user to create a weekly schedule for all sensors, (excluding Duress Buttons and Bill

Traps), to be inactive. Duress Buttons and Bill Traps linked to the system will not be

affected by inactive-times. During inactive-times, system will process duress button and bill

trap activations and ignore all other sensor activations.

Enter Start Time and End Time for the inactive periods desired for each day. To have the system

inactive over night the times will need to be bridged together between two days. This is done by

having the end time on the first day at 2400 and the start time on the following day at 0000 (see

SCOUT Console image – page 13). All inactive time entries must have a begin time and an end

time in order to function. The begin time must be earlier than the end time.

To delete all inactive times for all days click on the Clear All button.

www.response-technologies.com

- 15 -

Section 5

Console Configuration

Revised: January 9, 2015

Table of Contents