Deleting All Devices From The System; Siren Service / Operating Mode - Response SL2 Installation & Operating Manual

b) Confirm the new device ID code by
activating the Tamper Switch again on the
PIR/MAG detector within 15 seconds.
The siren will produce three short low
volume beeps and the Indicator / Learn
LEDs will stop flashing and remain ON for
3 seconds after which it will go out.
Note: If the valid signal is not received
within 15s the Indicator / Learn LEDs will
stop flashing and turn off and the siren
will produce a single long low volume
beep and exit Learn Mode.
3. The new PIR / MAG is now linked to the Siren
and its ID code recorded into the Sirens memory.
The siren will now return to Service Mode.
DELETING ALL DEVICES
FROM THE SYSTEM
Note: NVM reset can only be achieved at the siren,
it cannot be activated remotely from a linked
Remote Control or Keypad.
To delete all devices from the system
1. Switch the Solar Siren into Service Mode using
any Remote Control or Remote Keypad already
linked so it can be removed from the wall.
2. Inside the battery compartment press-and-hold
the learn button for 10s until the siren produces
two long low volume beeps and the learn LED
beside the learn button flashes 5 times. Ignore
the learn beep after the first 5 seconds.
The ID codes of all linked devices are now
erased from memory.
Note: The siren will now remain in Service Mode
as it cannot be switched to Operating Mode until a
remote control or keypad is linked to it which allows
it to be controlled.
SIREN SERVICE /
OPERATING MODE
Note: The Siren is automatically in Service Mode
when first powered up and must be switched into
Operating Mode before the system can be operated
or fully tested.
The siren can be switched between Service Mode
and Operating Mode using any linked Remote
Control or Keypad as follows:
Remote Control:
Press and hold the
Remote Keypad:
Enter the User Access Code, then press and
hold the DISARM button for 5 seconds:
? ? ?
User Access Code
The siren will generate the following signals to
indicate which mode it is switching into...
If switching into Service Mode:
As the button is pressed the Remote will
transmit the Disarm signal and the Siren will
beep twice as normal. This Disarms the system.
After the button has been held down for
5 seconds the "Siren Service Mode Toggle" command
will be transmitted and the siren will produce two short
beeps followed 1 second later by a single long beep.
The Siren LEDs will flash together in conjunction
with the beeps. Beeps to be normal volume.
beep-beep ...................... beeeeeeeeeep
If switching into Operating Mode:
As the button is pressed the Remote will
transmit the Disarm signal. The siren will not
respond to this as it is in Service Mode.
After the button has been held down for
5 seconds the "Siren Service Mode Toggle" command
will be transmitted and the siren will produce a single
long beep followed 1 second later by two short beeps.
The Siren LEDs will flash together in conjunction
with the beeps. Beeps to be normal volume.
beeeeeeeeeep ...................... beep-beep
Note: The siren will return to Operating Mode
into a Disarmed condition.
button for 5 seconds:
,
?
(hold 5
seconds)
1 second
1 second
19