Link Sensor; Unlink Sensor - Response CENTURION SCOUT Owner's Manual

LINK SENSOR

LINK SENSOR allows user to add an additional sensor to be monitored by the SCOUT. Once a
sensor is linked, it will remain linked to the system until unlinked by the user. All sensors
originally purchased with the system are linked and ready for use.
To link sensor:
 Open sensor case (small, slotted screwdriver is needed). Locate sensor "reset" button
(reference Inovonics Sensor Installation Instructions booklet for sensor "reset" button
location).
 Press LINK SENSOR key and follow verbal prompts. Press sensor "reset" button. Voice
prompt will confirm successful link.
 Close sensor case.
Note: Link Sensor will time-out after 30 seconds if "linking" is not confirmed. If time-out
occurs sensor will remain unlinked.

UNLINK SENSOR

UNLINK SENSOR allows user to make a previously linked sensor no longer monitored by the
SCOUT.
To unlink sensor:
 Open sensor case (small, slotted screwdriver is needed). Locate sensor "reset" button
(reference Inovonics Sensor Installation Instructions booklet for sensor "reset" button
location).
 Press UNLINK SENSOR key and follow verbal prompts. Press sensor "reset" button.
Voice prompt will confirm successful unlink.
 Close sensor case.
Note: Unlink Sensor will time-out after 30 seconds if "unlinking" is not confirmed. If time-out
occurs sensor will remain linked.
www.response-technologies.com - 9 -
Section 4
System Configuration
©Response Technologies, Ltd.
Revised: January 9, 2015