Remote Control; Other Operators; Keyboard Operation; Parameter Numbers And Values - KEB COMBIVERT F5 Servo Installation Manual

Operation of the Unit
RS232-cable 3m
PC / Operator
Part number 00.58.025-001D
4.1.4

Remote control

For remote control of the KEB COMBIVERT F5 a special HSP5 operator is available.
Operator
00F5060-9000
00F5060-9001
4.1.5

Other operators

In addition to the described operators the KEB COMBIVERT can be equipped with further
operators for special applications (Profibus, Interbus, Sercos, CAN, DeviceNet). You find
further information on that on our home page.
4.2

Keyboard Operation

4.2.1

Parameter numbers and values

When switching on KEB COMBIVERT F5 the value of parameter CP.1 appears.
The function key changes between the parameter
value and parameter number.
With UP (▲) and DOWN (▼) the value of the
parameter number is increased/decreased with
changeable parameters.
Principally during a change, parameter values are immediately accepted and stored non-
volatile. However, with some parameters it is not useful that the adjusted value is accepted
immediately. In these cases the adjusted value is accepted and stored non-volatile by
pressing ENTER. When this type of parameter is changed a point appears behind the
last digit.
By pressing „ENTER" the adjusted value is
accepted and non-volatile stored.
GB - 20
9 pole SUB-D female
Housing (PE)
Cable
The last three digits of the part number indicate the
00F50C0-2xxx
length of the cable in dm.
00F50C0-3xxx
9-pole SUB-D connector
2
3
5
PC
F5-Operator
STOP
START
2
3
7
FUNC.
SPEED
STOP
START
ENTER
F/R