JRC jue-87 Instruction Manual page 74

•
Printer which received message is routed to:
Set a port of printer connected. Choose the message type to print out:
- None: No connection
- Dte: Connecting with IME/DTE
Then, choose the message reception type from follows:
- All message: Print out all messages.
- Inm-c message only: Print out Inm-C message only.
- inm-c Distress and egc message only: Print out Inm-C Distress message and EGC message.
- Egc message only: Print out EGC message only.
•
Nav. equipment connected with MES:
* Choose the port connected with MES and interface condition, i.e. Nmea0183, nMea0182 or JRC
original, when you choose "Internal".
* Choose interface from "Nmea0183" or "nMea0182" when you choose "External". (as usual,
select "Nmea0183")
* Received sentence is GGA, RMC, GLL, GNS, ZDA and DTM. Baudrate is 4800 bps.
•
Buzzer sound duration for message received:
Set the buzzer sound duration for receiving routine or safety message. No sound occurs when you
set it as "0 sec".
However, when distress or urgent message is received, buzzer sounds continuously until alarm off
command (Ctrl + A ) is executed, or BUZ OFF switch of EXT. BUZ is pressed.
DTE message type
All message
Inm-c message only
inm-c Distress and egc message only
Egc message only
Fig.3.5.4 "DTE message type" Window
F10: Previous
3-14