Parameter Setting Polling For Scheduled Transmission - JRC jue-87 Instruction Manual

3.12.5 Parameter Setting Polling for Scheduled Transmission

Parameters of scheduled transmission are changeable from IME/DTE or the polling from land based
user. Firstly, land based user should read out the parameters with parameter read out command. Land user
will acquire the access code and parameters. The access code is changed by each command of reading out
and is required to change the parameters. Secondly, land user should change the parameters. When the
correct command is included in the receive message, the MES checks the access code then change the
parameters.
Command for parameters read out polling
/SR/XXX:XXX.....XXX/X..X/
Subscriber's number (up to 11-digit)
Destination code (3-digit)
Example of parameter read out polling
MES receives the following message:
/SR/072:02822351/TELEX/
MES transmits the following message to the land based user, destination code: 072, subscriber's
number: 02822351 via Telex:
MES NUMBER: 412345678
SCHEDULE
1 START
INTERVAL
LES
DESTINATION
NETWORK
CHARACTER
DATA
TRANSMIT
DELAY LOGGING OUT 00:00
ACCESS CODE: 123456
96-01-25
Network type [TELEX, PSDN or Vxx (for PSTN)]
96-10-10 19:00
12:00
202
123-123456789
TELEX
IA5
DS1 DS2
ON
3-89
3