JRC jue-87 Instruction Manual page 65

3.4.1 Command
JUE-87 has two kinds of way to operate the IME/DTE, one is selecting command by cursor, and the
other one is pressing the buttons directory. Direct commands make quicker and easy operation when you
get used to the operation of IME/DTE.
Selecting command by cursor, commands using Alt .key is not available when another window is
displayed on main menu screen. Use them after closed window with F10("Previous")key.
(1) Commands selecting by cursor
You can select the function below in the Main menu by moving the cursor to the item you want
and pressing
Enter
Transmit.................. To transmit messages.
read-Out.................. To read out received messages.
Edit ......................... To edit a message or to manipulate files.
call-Log .................. To display the history of both incoming and outgoing calls
Distress ................... To initiate a distress alert.
Ncs/les-info ............ To display the lists of LES or NCS, or to register newly operating LES or
receive-Mode.......... To select receive mode, i.e. Inmarsat-C mode or EGC reception mode.
egC ......................... To select EGC service type.
(2) Direct commands
You can select each function in the Main menu screen directly by pressing one of the following
keys while holding down
+ ........ Transmit
Alt T
+ ........ read-Out
Alt O
+ ........ Edit
Alt E
+ ........ call-Log
Alt L
+ ........ Distress
Alt D
+ ........ Ncs/les-info
Alt N
+ ....... receive-Mode
Alt M
+ ........ egC
Alt C
+ ........ To go to "Status", "set Up" and "diAgnostics".
Alt G
+ ......... Status
Alt S
NOTE
key.
NCS in the list.
key:
Alt
To display MES status or test results
•
MES status (line status, bulletin board error rate, ID, MES serial number
and delivery date)
•
Tests results (ROM/RAM test, performance test)
3-5
3