JRC jue-87 Instruction Manual page 66

+ ........ set Up
Alt U
•
•
•
•
•
•
+ ........ diAgnostics
Alt A
To display contents of data source, alarm history or software version.
Further instruction and/or selection items are displayed in the pop-up window every time you
select a function.
In each window, by pressing a capital character while holding down
function instead of moving the cursor.
The following commands are available by pressing a key with holding down
+ ....... Alarm off
Ctrl A
To stop sounding the alarm buzzer of the IME/DTE.
+ ....... MES position display ON/OFF
Ctrl L
To alternate MES position display ON and OFF
+ ...... log-Out
Ctrl O
To initiate a log-out request.
+ ....... MES communication status display ON/OFF
Ctrl F
To alternate MES communication status display ON and OFF.
+ ....... Printer status display ON/OFF
Ctrl Z
To alternate MES printer status display ON and OFF.
Msg print on ........................ Automatic printout function ON
Msg print off........................ Automatic printout function OFF.
DTE ..................................... Printer is routed to IME/DTE.
All Messages ....................... All messages are printed out.
Distress & EGC ................... Distress and EGC message are printed out.
EGC Only ............................ EGC message only is printed-out.
(Note: All EGC SafetyNET message with "Urgency" and "Distress"
priority message are printed out automatically regardless printer setup
as required by IMO.)
To set the current date & time;
To initiate a Log-out, Log-in or performance test;
To register each parameter for scheduled transmission;
To register land ID for polling;
To select the closed network ID;
To select the function of peripheral equipment connected with IME or
DTE.
3-6
key you can select
Alt
key:
Ctrl