1.
he propeller should not touch any
part of the spinner cone. If it does, use a
sharp modeling knife and carefully trim
away the spinner cone where the propel-
ler comes in contact with it.
2.
HINGING THE ELEVATORS
Locate the items for this section of the
manual.
1.
Carefully remove the elevator from one
of the horizontal stabilizer panels. Note
the position of the hinges. Used C/A glue
to ix the hinges position.
2.
3.
C/A glue
Remove each hinge from the horizon-
tal stabilizer panel and elevator and place
a Tpin in the center of each hunge. Slide
each hinge into the elevator until the T-
pin is snug against the elevator. his will
help ensure an equal amount of hinge is
on either side of the hinge line when the
elevator is mounted to the horizontal sta-
bilizer panel.
4.
Epoxy
23