Configuring A Remote Log Server - Allied Telesis T-8100L/8 User Manual

Configuring a Remote Log Server

You can use the AT-8100 web browser interface to enable logging to a
remote log server, which is part of the Syslog feature. However, you must
use the CLI to view or clear the event log. For information about the Syslog
features, see the SysLog chapters in the AT-8100 Series Version 2.2.5.0
Management Software Command Line Interface User's Guide.
To activate remote logging on the switch, do the following:
1. Hover the cursor over the System tab.
2. From the System tab, hover over System Settings.
The System Settings tab is displayed. See Figure 9 on page 41.
3. Move the cursor to the right and select Services.
The System Services page is displayed. See Figure 13 on page 45.
4. Specify the following fields:
Remote Log— Check the checkbox to enable the switch to send

status and error messages to a remote log server. To disable the
switch from sending messages to a remote log server, uncheck the
checkbox.
Server IP Address— Enter the IPv4 address of the remote log

server in the IPv4 format: nnn.nnn.nnn.nnn.
5. Click Apply.
6. Click SAVE to save your changes to the startup configuration file.
AT-8100 Series Version 2.2.5.0 Web Interface User's Guide
47