Allied Telesis T-8100L/8 User Manual page 286

Chapter 25: LLDP and LLDP-MED
286
Holdtime Multiplier— Enter a holdtime multiplier value. The

transmit interval is multiplied by the holdtime multiplier to give the
Time To Live (TTL) the switch advertises to the neighbors. The
range is 2 to 10. The default value is 4.
Non Strict Med TLV Order Check— Check the checkbox to set

the switch to accept LLDP-MED advertisements, even if the TLVs
are not in the standard order, as specified in ANSI/TIA-1057. This
configuration is useful if the switch is connected to devices that
send LLDP-MED advertisements in which the TLVs are not in the
standard order. By default, this checkbox is not selected.
Notification Interval— Enter a notification interval. This is the

minimum interval between LLDP SNMP notifications (traps). The
range is 5 to 3,600 seconds. The default value is 5.
Reinit— Enter a reinitialization delay. This is the number of

seconds that must elapse after LLDP is disabled on a port before it
can be reinitialized. The range is 1 to 10 seconds. The default
value is 2.
Tx Delay— Enter a transmission delay. This is the minimum time

interval between transmissions of advertisements due to changes
in LLDP local information. The range is 1 to 8192 seconds. The
default value is 2.
Total Neighbors— Indicates the number of LLDP neighbors the

switch has discovered on all its ports.
Neighbors Last Update— Indicates the time since the LLDP

neighbor table was last updated.
5. Click Apply.
6. Click SAVE to save your changes to the startup configuration file.