Adding A Radius Server; Figure 72: Radius Server Add Page - Allied Telesis T-8100L/8 User Manual

Adding a
RADIUS Server
AAA Accounting— Select a RADIUS accounting setting. Choose

from the following:
Start-Stop: Indicates that a start accounting message is sent at
the beginning of a session, and a stop accounting message is
sent at the end of the session.
Stop-Only: Indicates a stop accounting message is sent at the
end of the session.
None: Indicates that sending accounting messages is disabled.
4. Click Apply.
The Active Authentication Server field shown on the upper middle of
the page indicates "RADIUS."
5. Click SAVE to save your changes to the startup configuration file.
To add a RADIUS server, do the following:
1. Click Add near the RADIUS server list.
The RADIUS Server Add page is displayed. See Figure 72.
Figure 72. RADIUS Server Add Page
2. Configure the following as needed:
IP Address— Enter the IP address of a RADIUS server on the

network. The IP address must be in the following IPv4 format:
xxx.xxx.xxx.xxx.
AT-8100 Series Version 2.2.5.0 Web Interface User's Guide
193