Configuring A Telnet Or Ssh Server; Figure 13: System Services Page - Allied Telesis T-8100L/8 User Manual

Configuring a Telnet or SSH Server

The AT-8100 web browser interface allows you to configure the switch as
a Telnet or SSH server.
You can use the web browser interface to enable a Telnet server, but not
as a Telnet client. The Telnet client is only supported from the Command
Line Interface (CLI). For information about how to use a Telnet client, see
the AT-8100 Series Version 2.2.5.0 Management Software Command
Line Interface User's Guide.
To enable an SSH server in the web interface, you must first create an
encryption key in the CLI interface. Then you can enable the SSH server in
the web interface.
To enable Telnet or SSH server on the switch, do the following:
1. From the home page, hover the cursor over the System tab.
2. From the System tab, hover over System Settings.
The System Settings tab is displayed. See Figure 9 on page 41.
3. Move the cursor to the right and select Services from the drop-down
menu.
The System Services page is displayed. See Figure 13.
Figure 13. System Services Page
4. Specify the following fields as necessary:
Telnet— Check the checkbox to enable the Telnet server on the

switch. To disable the server on the switch, uncheck the checkbox.
SSH— Check the checkbox to enable the SSH server on the

switch. To disable the server on the switch, uncheck the checkbox.
AT-8100 Series Version 2.2.5.0 Web Interface User's Guide
45